Pentair SPACOMMAND CP3800 Series - Kit Components Overview

SCREENLOGIC
®
INTERFACE Wireless Connection Kit Installation Guide
1
ScreenLogic
®
Interface Wireless Connection Kit
The ScreenLogic
®
Interface Wireless Connection interface consists of an
indoor and outdoor wireless 2.4 GHz transceiver. Note: The transceivers
ship from the factory as a matched pair. The ID numbers on each
transceiver must be the same number to function correctly. Transceivers
are replaced as a matched pair. For more information, call Customer
Support (880) 831.7133.
The transceivers provides a wireless connection between the
ScreenLogic Interface Protocol adapter and the IntelliTouch
®
or
EasyTouch
®
Control System Load Center located at the equipment pad.
This wireless connection eliminates the existing hard wire connection
from inside your home to the equipment pad.
Wireless Connection Kit Contents
The following items are included in the Wireless Connection kit.
• One ScreenLogic Interface indoor wireless transceiver with AC
power adapter and one foot connection cable with attached plugs.
• One ScreenLogic Interface outdoor wireless transceiver with
10 ft. cable, provided in kit with enclosure and mounting hardware.
• ScreenLogic Interface Wireless Connection Installation Guide
(this manual)
ScreenLogic Interface Wireless Connection Kit Contents
2X
4X
Mounting hardware
4X
2X
Outdoor
Transceiver
enclosure
Cable (for connection to ScreenLogic
Interface Protocol Adapter
(purchased separately)
Outdoor
transceiver
Indoor transceiver
AC transformer
Outdoor Cable
(white - 10 ft.)
NOTICE: ID’s on Indoor
and outdoor transceiver
must match
ID NUMBER
ScreenLogic Interface Protocol Adapter
(purchased separately)
Protocol Adapter
LAN
LABEL P/N 520535
RESET
SERIAL CONNECTION Black Green Yellow Red
P/N 520489