SPACOMMAND
®
Spa-Side Remote Installation and User’s Guide
Step 2: Mount the SpaCommand
®
Spa-Side Remote
(with existing mud-box)
To install the SpaCommand Spa-Side Remote into the existing mud-box:
1. Tape the existing cable that is in the mud-box conduit to the new remote
cable. Disconnect the cable connected to the COM port in the load center.
Pull the wire connected to the new remote through the conduit into the load
center conduit. Leave enough slack to connect the new cable connector to
the rear socket of the remote. Note: If necessary, use a “Fish Tape” or similar
method to pull the wire through long conduit runs with multiple bends.
2. Mount the bracket: Insert the remote wire connector through the bracket
opening. Mount the remote bracket onto the front of the mud-box. Note: If
required, cut the lower edge of the conduit to align the cable connector
and bracket (see illustration on next page).
Position the bracket: Use the vertical screw hole slots to position the bracket
so that the top edge of the remote is level with the spa wall coping (see
diagram on next page). Note: If necessary, use the upper bracket screw holes
for standard remote mud-box positioning. Align the bracket screw holes with
the mud-box screws holes and secure the bracket in place with the two
screws.
3. Connect the Cable Connector: Place the O-RING over the round socket on
the rear of the remote. Insert the connector into the socket. The connector is
keyed for the correct pin alignment. Be sure the connector fits flush against
the back of the remote front panel. Secure the connector to the rear of the
remote with the two screws. Be sure that the wire in the mud-box is not
pinched.
4. Place the remote onto the bracket. Press evenly on the bracket to secure in
place.
11
Existing
Mud-box
Cable
connector
Bracket
Remote (rear view)
O-RING
Screw (x2)
Connector
(keyed)
Screw (x2)
Remote
(front panel)
Screw (x2)
Socket
Note: Do not install the spa-side
remote below the spa water level.
To Next Page
Loading...
Need help?
General
