Why does the Pentair AUTOTROL 460TC Control Systems time display keep advancing?
If the time display on your Pentair Control Systems continues to advance, the cause may be a defective time set switch. Replacing the timer should resolve this issue.
General| Power Supply | 24 VAC |
|---|---|
| Control Type | Electronic |
| Cycle Adjustment | Yes |
| Voltage | 24 VAC |
| Timer | Digital |
| Backup | Battery backup |
| Mounting | Top mount |
| Warranty | 1 year limited |
| Regeneration | Time initiated |
| Programming | 7-day |
| Valve Size | 1 inch |
| Frequency | 50/60 Hz |
| Enclosure | NEMA rated |
Stores data during power outages using NOVRAM for seamless operation.
Dynamically adjusts reserve capacity based on past usage for economy.
Reacts to sudden increases in usage by adjusting reserve for anticipated high demand.
Ignores days with minimal usage for accurate average calculation, e.g., during vacations.
Features solid-state electronics and a simple metering system for long-term performance.
Sets the current time of day to the nearest hour for regeneration scheduling.
Configures the water hardness level (GPG/PPM) for accurate regeneration cycles.
Sets the water softener's capacity in kilograins for regeneration control.
Shows the current time of day, with PM indicator for accuracy.
Flashes when conditioned water flows, confirming meter operation.
Settings are retained during power outages, no reprogramming needed.
Initiates an extra regeneration for periods of high water usage.
Sets the current time of day for regeneration timing.
Configures the number of days between automatic regenerations.
Selects between standard AM/PM or 24-hour clock display.
Retains settings and data during power outages via NOVRAM.
To Next Page