What does ERR3 mean on my Pentair AUTOTROL Performa 265 Control Unit and how do I fix it?
If your Pentair Control Unit shows an ERR3 error, it means the camshaft rotated for more than 5 minutes trying to find the Home position. If the motor keeps rotating indefinitely, replace the following components in this order: the wire harness, the motor, the optical sensor, and finally, the controller.
What does ERR 2 mean on my Pentair Control Unit?
If your Pentair Control Unit displays 'ERR 2', it indicates that the controller power does not match 50 or 60 Hz. Try disconnecting and reconnecting the power. If the problem persists, you may need to obtain a controller or AC transformer that is appropriate for your power frequency.
General| Brand | Pentair |
|---|---|
| Model | AUTOTROL Performa 265 |
| Category | Control Unit |
| Language | English |
Covers general hazards, personnel qualifications, and safety precautions related to material and electrical components.
Lists design specifications, pressure ratings, temperature limits, and flow rates for the valve.
Presents a graph illustrating pressure drop versus flow rate for service and backwash cycles.
Details the sequence and purpose of each step in an 8-cycle regeneration process.
Table mapping vessel diameter to injector and flow controller settings for softener configuration.
Details how to connect the valve to the piping system, including flexible connections and electrical hookups.
Provides instructions for drain line connections, including tubing size, elevation, and air gap requirements.
Guides the user through setting up system size, time, day, regeneration, salt, and hardness parameters.
Provides steps to reset the controller to its factory default settings, requiring full reprogramming.
Covers initial water filling, softener activation, and manual regeneration steps for commissioning.
Details the necessity and methods for disinfecting water softeners using hypochlorite or electrochlorination.
Explains how to initiate manual regeneration, advance cycles, and cancel an ongoing regeneration process.
Procedure for replacing the motor and camshaft assembly, including necessary disconnections.
Instructions for replacing the optical sensor and the main controller module.
Lists common error codes for the Logix controller and provides causes and recovery steps.
Addresses common issues with the Performa valve, such as brine tank overflow and water leakage, with troubleshooting steps.
An illustrated list of valve components with part numbers and packaging quantities.
To Next Page