EasyManua.ls Logo

Pentair BLUEFURY LITE - Cleaner Components

Pentair BLUEFURY LITE
76 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
371885 (REV 12/2016) 4
English
CLEANER OVERVIEW
Overview
The BLUEFURY
®
LITE Pressure Side Pool Cleaner travels in a random paern throughout the pool, vacuuming and sweeping
the boom. The climbing ability of the BLUEFURY LITE is dependent on the pools shape. It will climb beer in pools without
sharp angles or curves in theo transion from the pool oor to the pool wall.
Approximately every 3-1/2 minutes the cleaner will go into back up mode. At this me the Backup Valve will pull the cleaner
away from its last locaon, allowing the cleaner to bypass any obstrucon and help randomize the pool coverage.
Note: Before you install and operate your cleaner, read
through these important guidelines:
1. Always disconnect the cleaner from the pool wall when
cleaning or back washing the pool lter.
2. Dirt in the plumbing will clog the cleaner. Aer cleaning
or back washing the lter, let the ltraon system run
for at least ve minutes before reconnecng the cleaner.
3. New plumbing lines should be ushed out before
installing the cleaner.
4. The cleaner should not be used to remove plaster dust
in new pools.
5. Always remove the cleaner before swimmers enter the
pool.
6. Always handle the cleaner with care.
7. Always pick up the cleaner by the handle, especially
when liing the unit out of the water.
8. Do not handle the cleaner while it is operang.
9. Always remove the cleaner from the pool before
chemical shock treatments (super chlorinate). As a rule,
any pool water that is unsafe for swimming is unsafe for
the cleaner.
10. Carefully cut the feed hose following the instrucons on
page 3.
11. By following these simple guidelines, you can help
protect against injury and prolong the life of your
cleaner.
12. Refer to “Important Warning And Safety Instrucons”
on pages ii - iii for addional installaon and safety
informaon.
1. BLUEFURY LITE Cleaner Head
2. Debris Bag
3. Sweep Hose
4. Feed Hose Assembly (Not shown)
2-10 . [3 m.] secons
1-7.5 . [2.3 m.] secon
1-2.5 . [0.8 m.] secon
5. Backup Valve (Not shown)
6. Wall Fing
7. Wall Adapter
8. Debris Seal
Note: The cleaner system is delivered with
debris seal installed inside of cleaner head.
9. Flow Gauge
Cleaner Components
1
2
8
6
7
9
3