Pentair BLUEFURY LITE - Assembling the Cleaner; Pre-Use Checklist; Using the Cleaner

To Next Page

To Previous Page

371885 (REV 12/2016) 8

English

Assembling the Cleaner

1. Aach the Quick Connect ng on the end of the hose to the feed tube on the BLUEFURY

LITE Pressure Side Pool Cleaner.

Be sure the snaps are engaged.

2. Aach the debris bag to the cleaner. Push the bag over vacuum tube to click it into place.

3. Review checklist before use:

• Hoses cut properly and oats evenly spaced.

• Mender nuts are ght on feed hose.

• Wall ng secure and in place.

• Debris bag and hose assembly aached.

• Ensure debris seal is aached. See Figure 9.

Using the Cleaner

1. Lower the cleaner carefully into pool.

2. Switch ON the FILTER PUMP.

3. Wait at least 60 seconds to allow air to blow out of the hose.

4. Switch ON the BOOSTER PUMP.

Assembling the Cleaner

Debris Bag

Sweep Hose

Quick Connect Fing

(with built-in swivel)

Feed Tube

Lead Hose

Mender Nut

Debris Seal

Figure 9

Feed Tube