Pentair BLUEFURY LITE - Connecting Hose Sections; Verifying Hose Length

371885 (REV 12/2016) 7
English
Step 3: Connecng Hose Secons
1. Aer the hose secons have been cut to size, reconnect
them by pushing the hose end over the barb on the swivel.
Note: Be sure to push the hose all the way to the boom
of the barb.
2. Move the mender nut toward the hose by turning clockwise
and rotang unl ght on hose. Use pliers if needed.
Note: Be sure the same number of oats are le on hose
secons 2 and 3, as described in Step 2 on page 3.
3. To check that the hose is cut to the correct length, reconnect
the hose and wall ng to the wall adaptor. Take the
opposite end of the hose assembly and walk to the farthest
point of the pool from the wall adaptor. The hose should
reach the edge of the pool but should not extend more
than 6 inches (15 cm) beyond the pool edge.
4. You can now connect the cleaner to the hose.
Connecng the Hoses to Swivels
Barb on Swivel
Feed
Hose
Mender Nut
WATER FLOW
DIRECTION
Figure 7
Figure 8
WALL FITTING
FARTHEST POINT OF
POOL PERIMETER
FROM WALL FITTING
BACK UP
VALVE
LEAD
HOSE
SECOND
SWIVEL
FEED HOSE (2)
FIRST
SWIVEL
FEED HOSE
(1)