Pentair BLUEFURY LITE - Cleaner Adjustments and Operation; Cleaner Operation Details; Cleaning the Debris Bag; Cleaning the In-Line Filter Screen

371885 (REV 12/2016) 9
English
CLEANER ADJUSTMENTS AND OPERATION
Cleaner Operaon
Note: The BLUEFURY
®
LITE Pressure Side Pool Cleaner may need some minor
adjustments to ensure it is operang properly and to get the best performance
possible.
When operang correctly, the cleaner will travel in a random paern throughout
the pool, vacuuming and sweeping the pool.
• The climbing ability of the cleaner depends on the pool structure and water
ow.
• Two hour cleaning cycle is recommended for average size residenal (15’ x
30’ [4.6 m x 9.1 m]) pools.
• It will perform more eciently in pools without sharp transions between
pool oor and walls.
• The cleaner goes into a back up mode approximately every 3-1/2 minutes for approximately 15 seconds.
• If pool has a high level of debris, run the cleaner in two short cycles. Empty the debris bag between cycles.
Cleaning the Debris Bag
1. Detach the bag strap from the hose.
2. Press the release buon on the cleaner vacuum tube and carefully pull up to
remove the bag from the cleaner. See Figure 10.
3. Open bag closure by pulling apart the fabric tabs at the top of the bag (see
Figure 11). Holding the boom of the bag, turn over to empty debris out of
the top. If needed, rinse bag with a hose.
4. To close, press together the hook and loop fabric at the top of the bag and run
nger along enre length of bag so it is completely closed.
5. Be sure debris seal is on the vacuum tube. See Figure 9, on page 5.
6. Slide the debris bag collar over the vacuum tube unl it clicks in place.
7. Reaach the strap onto the feed hose.
8. To keep bag from folding during operaon, aach the strap above rst feed
line oat. Slide oat down if needed.
Note: It is easier to empty the debris bag when it is dry. A second bag
(purchased separately) may be used while the used debris bag is drying.
Cleaning the In-Line Filter
When cleaning the cleaner’s debris bag you should also inspect the in-line lter’s debris screen. The debris screen will be found
roughly 18 inches (45.7 mm) from the wall ng.
To clean the in-line lter’s debris screen:
1. Pull the cleaner out of the water and place it at on the
pool deck.
2. Twist apart the lter housing cap and lter housing.
3. Remove the debris screen from the lter housing and
remove all debris. Use a hose to ush out any dirt.
4. Reinstall the debris screen into the lter housing and thread
the housing cap back onto the housing. Hand ghten only.
Figure 10
Bag Release
Buon
Figure 11
Use tabs to pull
bag apart
To Cleaner
From Wall Fitting
Filter Housing
Cap
Filter
Housing
Figure 12