What to do if my Pentair Water Pump fails to regenerate?
If your Pentair Water Pump isn't regenerating, first ensure it has continuous electrical service by checking the fuse, plug, pull chain, or switch. If the power supply is OK, the timer might be faulty and need replacement. Also, check if there was a power failure and reset the time of day.
Why is my Pentair Water Pump using too much salt?
If your Pentair Water Pump unit is using too much salt, you should first check the salt usage and salt setting to make sure it is properly set. Also, excessive water in the brine tank can cause this issue. Refer to the section that addresses 'Excessive water in brine tank'.
Why is my Pentair Water Pump softener failing to draw brine?
If your Pentair Water Pump softener isn't drawing brine, start by cleaning the drain line flow control. Next, clean the injector and the injector screen, as these are common culprits. Ensure that the line pressure is at least 20 psi. If the issue persists, there might be an internal control leak, requiring you to change the seals, spacers, and piston assembly. Finally, check the drive motor and switches to see if the service adapter did not cycle.
General| Model | 2510 Econominder |
|---|---|
| Inlet/Outlet | 1" NPT |
| Brine Line | 3/8" |
| Distributor Pilot | 1.05" OD |
| Electrical | 120V, 60 Hz |
| Pressure Rating | 125 psi |
| Operating Pressure | 20 - 125 psi (1.4 - 8.6 bar) |
| Brine Draw Flow | 0.5 gpm |
| Temperature Rating | 40 - 110° F (4 - 43° C) |
| Operating Temperature | 40 - 110° F (4 - 43° C) |
Step-by-step guide for physically installing the water softener unit.
Procedures for initial operation and testing after installation.
Procedure for setting the days water conditioner regenerates using the skipper wheel.
Steps to adjust the specific time the regeneration cycle begins.
Procedure to set the current time on the 24-hour gear.
Programming the regeneration cycle using pins and holes on the wheel.
List of specialized tools required for seal and spacer replacement.
Detailed instructions for replacing seals and spacers in the valve body.
To Next Page