Need help?Do you have a question about the Pentair FLECK 5000 and is the answer not in the manual?
General| Model | Fleck 5000 |
|---|---|
| Meter | Optional |
| Max Pressure | 125 psi |
| Valve Type | Piston-operated |
| Application | Water Softening/Filtration |
| Inlet/Outlet | 1" NPT |
| Drain Line | 1/2" NPT or 3/4" NPT |
| Operating Pressure | 20 - 125 psi (1.4 - 8.6 bar) |
| Water Temperature | 34 - 110°F (1 - 43°C) |
| Drain Line Connection | 1/2" NPT or 3/4" NPT |
| Power Supply | 24V Transformer |
| Operating Temperature | 34 - 110°F (1 - 43°C) |
| Materials | Noryl, Brass |
| Control Type | Timer or Metered |
Methods for disinfecting water softeners to prevent off-tastes or odors.
Proper connection of the drain line, including air gap requirements.
Importance of installing a bypass valve if the unit is not equipped with one.
How the control operates and stores programming during programming mode.
Steps to manually start a regeneration cycle using the control buttons.
How the SXT control handles power outages and resumes operation.
Setting the unit of measure and time display format.
Specifying the type of cycle the valve follows during regeneration.
Setting the treatment capacity of the system media.
Entering the hardness of the inlet water for calculation.
Setting the duration for each regeneration cycle step.
To Next Page