Pentair FLECK 5000 - Diagnostic Programming Mode; Diagnostic Programming Mode Steps

PENTAIR FLECK 5000 Control Valve Service Manual • 13
DIAGNOSTIC PROGRAMMING MODE
Diagnostic Programming Mode Options
Abbreviation Parameter Description
FR Flow Rate Displays the current outlet
ow rate
PF Peak Flow Rate Displays the highest ow rate
measured since the
last regeneration
HR Hours in Service Displays the total hours that the
unit has been in service
VU Volume Used Displays the total volume of
water treated by the unit
RC Reserve Capacity Displays the system’s reserve
capacity calculated from the
system capacity, feedwater
hardness, and safety factor
SV Software Version Displays the software version
installed on the controller
NOTE:
Some items may not be shown depending on
timer conguration.
The timer will exit Diagnostic Mode after 60 seconds if
no buttons are pressed.
Diagnostic Programming Mode Steps
1. Press the Up and Extra Cycle buttons for ve seconds while
in service.
2. Press the Up button. Use this display to view the current
Flow Rate. This option setting is identied by “FR” in the
upper left hand corner of the screen.
3. Press the Up button. Use this display to view the Peak Flow
Rate since the last regeneration cycle. This option setting is
identied by “PF” in the upper left hand corner of the screen.
4. Press the Up button. Use this display to view the Hours in
Service since the last regeneration cycle. This option setting
is identied by “HR” in the upper left hand corner of the
screen.
5. Press the Up button. Use this display to view the Volume
Used since the last regeneration cycle. This option setting is
identied by “VU” in the upper left hand corner of the screen.
6. Press the Up button. Use this display to view the Reserve
Capacity. This option setting is identied by “RC” in the upper
left hand corner of the screen.
7. Press the Up button. Use this display to view the Software
Version. This option setting is identied by “SV” in the upper
left hand corner of the screen.
8. Press the Extra Cycle button to end Diagnostic Programming
Mode.