What to do if it has been more than 7 days since the last regeneration on my Pentair Control Unit?
To recover from this error with your Pentair Control Unit, you must initiate a regeneration or set at least one individual day to 1, because all individual settings (d1, d2, d3, d4, d5, d6, d7) are set to 0.
What to do if my Pentair Control Unit displays a control board memory failure?
Perform a Master Reset on your Pentair Control Unit. If the error returns, do not attempt to troubleshoot this problem any further.
What to do if the drive motor is stalled on my Pentair Control Unit?
Unplug the Pentair Control Unit from the power source.
General| Model | Fleck ProFloSXT Downflow |
|---|---|
| Valve Type | Downflow |
| Warranty | 5-year limited warranty |
| Control Valve | Fleck SXT |
| Tank Size Compatibility | 8" to 16" diameter tanks |
| Connection Size | 1" |
| Cycle Options | backwash, brine draw, slow rinse, brine refill |
| Display | LCD display with intuitive interface |
| Programming | Fully programmable regeneration cycles |
| Bypass Valve | bypass valve |
| Control Type | Electronic |
Guide for setting the current time on the control unit.
Explains regeneration triggered by water usage depletion.
Explains regeneration triggered at a set time after usage depletion.
Explains regeneration based on a fixed time interval.
Explains regeneration scheduled on specific days of the week.
Describes how the control displays regeneration status and timing.
Details how programming mode affects normal operation.
Procedure to start a regeneration cycle manually.
Explains system behavior and memory retention during power outages.
Settings for display format, valve type, control type, and tank configuration.
Configuration of unit capacity, reserve selection, and safety factor.
Settings for day override, regeneration time, and cycle step durations.
Settings for flow meter type and pulse rate.
Adjustments for day override, regeneration time, hardness, reserve, and current day.
Displays current and peak water flow rates since last regeneration.
Shows total service hours and volume of water treated.
Displays calculated reserve capacity and controller software version.
Addresses issues with regeneration failure, hard water, and mineral contamination.
Troubleshoots problems related to excessive salt usage and loss of water pressure.
Covers issues with brine tank water levels and brine draw failures.
Addresses continuous control cycles and drain flow problems.
Explains error codes, their probable causes, and recovery procedures.
Guide for replacing key internal components of the control valve.
Procedure for replacing the piston assembly in the control valve.
Instructions for replacing seals and spacers within the valve.
Steps for removing and replacing the flow meter module.
To Next Page