Pentair FLECK 2910 NXT User Manual

User Guide Fleck 2910-NXT
6 / 36 Ref. MKT-UG-002 / B - 26.06.2018
3.3. Components description and location
3.4. Bypassing
If the system is equipped with a bypass and if a problem occurs, turn the valves to bypass the system as shown in the picture
below.
4 . Programming
Note: The controller must be plugged in to be programmed.
After 5 minutes with no button pressed, the unit returns to normal operation without saving.
4.1. Basic programming
Note: Menus are displayed in a defined and incremental order.
Choice of language
Feed water hardness
Note: This parameter is not visible in Timeclock mode, and allows to adjust the water hardness in °tH.
Calendar override
Note: Determine the maximum number of days of operation without regeneration.
A Press and simultaneously for 5 seconds to enter the menus sequence.
B Select the language to be displayed with and .
C Press to validate the selection and advance to the next parameter.
SELECT LANGUAGE:
ENGLISH
D Adjust the hardness with and .
E Press to validate the selection and advance to the next parameter.
WATER HARDNESS
DEGREE 0030fTH
F Adjust the number of days with and .
G Press to validate the selection and advance to the next parameter.
CALENDAR
OVERRIDE 03 DAYS
Shift button
UP/DOWN button
LCD display
Regen button
Outlet
ON/OFF Line Indicator
Meter
Injector
Drain
Meter connection
Diagnostic button
Inlet
Status LED
In Bypass
In InOut Out
Softening
System
Softening
System
Normal
operation
Fleck_2910-NXT_UG_VV_Multilingual.book Page 6 Mardi, 26. juin 2018 4:01 16

Pentair FLECK 2910 NXT Specifications

General

Brand	Pentair
Model	FLECK 2910 NXT
Category	Water Dispenser
Language	English