How to fix motor run-ON error in Pentair Water Filtration Systems?
For a motor run-ON error or cycle sense error on your Pentair Water Filtration System, which is a non-critical error indicating an extra optical sensor pulse was detected, press any button to clear the error or press to advance the motor to clear the error.
What to do if Pentair FLECK 5810 SXT has regeneration failure?
To address a regeneration failure in your Pentair Water Filtration System, perform a manual regeneration to reset the error code. If the system is metered, verify that it is measuring flow by running service water and watching for the flow indicator on the display. If the unit doesn’t measure flow, verify that the meter is working properly and its cable is well connected. Enter master programming mode and verify that the unit is configured properly. Check that system capacity, day override, and meter are identified correctly, and correct the settings as necessary.
How to resolve memory error in Pentair Water Filtration Systems?
To resolve a memory error in your Pentair Water Filtration System, perform a hard reset and reconfigure the system via master programming mode. Step the valve through a manual regeneration. If the error reoccurs, unplug the unit, put it into bypass, and contact a dealer.
What to do if Pentair FLECK 5810 SXT Water Filtration Systems shows fail safe error?
To address a fail-safe error in your Pentair Water Filtration System, unplug the unit and plug it back in. If the error reoccurs, unplug the unit, put it into bypass, and contact a dealer.
General| Brand | Pentair |
|---|---|
| Model | FLECK 5810 SXT |
| Category | Water Filtration Systems |
| Language | English |
To Next Page
