11
TECHNICAL DATA
CHAPTER 3
(*) These data refer to Fig. 1, Pag. 91. Measurements are expressed in millimetres.
The maximum ow rates given are reached if the pump is used without the check valve supplied.
The pumps of this series are not suitable for table fountains or aquariums. In these cases, it is neces-
sary to use a H07 RN-F cable. If these pumps are used in continuous mode for ponds with sh, it is
necessary to check them at regular intervals of 6 months (if the water contains aggressive substan-
ces). It is also advisable to check the maximum dimension of particles recommended for the pump
and take the necessary measures to prevent the sh from being sucked into the pump.
TECHNICAL DATA DPC 200/10
Mains voltage / Frequency
230 V ~ 50 Hz
Absorbed power 650 Watt
Type of protection / Insulation class IP 68 / F
Delivery tting 1
1/4"
Maximum ow rate 11.500 l/h
Maximum head 10 m
Maximum depth of immersion 9 m
Power cable 10 m H05 RNF
Weight (without power cord) 4,8 Kg
Maximum dimension of pumped solid particles 5 mm
Maximum temperature of the pumped uid (in continuous mode) 40° C
Maximum number of starts per hour (uniformly distributed) 30
Minimum priming level (A)* 15 mm
Minimum suction level (B)* (manual mode) 3 mm
Start level (C)* (automatic mode) 140 mm
Stop level (D)* (automatic mode) 30 mm
EN
To Next Page
Loading...
