Pentair Jung Pumpen DRENA-LINE Series - Start-Up

14
The integrated oating switch is disabled so that the pump can run in continuous mode:
MANUAL MODE:
1. Lift the front lever and place it
in position "MAN" (see Fig. 1).
2. To start the pump, insert the
plug in a 230 V current socket.
EN
Start-up (see g. 1 pag. 91)
CHAPTER 6
Use the pump for the applications listed on the nameplate.
WARNING
INSTRUCTIONS FOR A SAFE PUMP START
AUTOMATIC MODE
The power cable should have a minimum section equivalent to that of H05 RN-F. To be able to use the
pump outdoors, it is necessary to use cable with a length of 10 m. The plug and connections should be
protected by water splashes.
The maximum suction level of 3 mm can be reached in manual mode only. If the level of the uid to
suck is below 20 mm, maximum suction, up to a residual level of 3 meters, can be attained more
quickly by starting and topping the pump 2 or 3 times.
Pentair DPC pumps have an integrated oating switch. When the water reaches the start-up level, the
integrated oating switch automatically starts the pump.
When the water falls below the stop level, the integrated oating switch stops the pump.
1. Lower the front lever and
place it in location "AUT" (see
Fig. 1).
2. Place the pump in a stable
and straight position so that
the integrated oating switch
is able to move freely.
3. To start the pump, insert the
plug in a 230 V current socket.