Pentair LEGEND - Checking Wheel RPM

LEGEND® INSTALLATION MANUAL
If you have any additional questions,
please contact Pentair Pool Products Inc.,
Technical Support Department at:
1-800-831-7133, Monday through Friday.
G. Fine Tuning the Legend
®
3. Checking Wheel RPM
To determine whether the Legend
®
is receiving the
proper water pressure, turn off the pool pump, and
carefully remove the Legend
®
from the pool.
8
Mark the front drive Tire/Wheel with a marker, or
use the Pentair logo located on the side of tire as a
marker to count the rotations of the wheel per minute.
Have someone turn on pool pump and the booster
pump while you place the Legend
®
in the pool just
beneath the water surface. (Be sure to hold onto
the Sweep Hose to avoid getting wet).
Count the rotations of the marked wheel for exactly
one minute. (Be sure the Back-Up Valve isn't cycling
at this time). The rotations will give you the
Revolutions Per Minute. (RPM)
For proper performance, the Legend
®
operates
between 28-32 RPM. If the RPM is below 28 then
call your local Pool Professional or contact our
Technical Support Department at 1-800-831-7133.
If the RPM is more than 32, at the Wall Fitting, unscrew
the Pressure Relief Valve slowly until the RPM falls
between 28-32.