LEGEND® INSTALLATION MANUAL
III. Operation/Periodic Maintenance
A. Connecting/Disconnecting the
Legend
®
Turn off the booster pump and pool pump. Then take
the Wall Fitting and twist lock the Wall Fitting
clockwise into the Wall Adapter. To disconnect the
Legend
®
, unlock and twist counter-clockwise. The
Wall Adapter should remain in the pool wall.
B. Turning On/Off the Legend
®
The Legend
®
operates off the booster pump coming
from the equipment pad, and can be turned on or off
by merely turning on/off your booster pump time
clock.
C. Cleaning the Sand & Silt Bag
Carefully unlock the debris bag from the vacuum tube
and open the Velcro
®
Brand fastener at the top of
debris bag and dump debris.
If you have a lot of debris in your pool, especially
after a storm, you can run your Legend
®
in two
shorter cycles per day and empty the debris bag
between cycles.
Reconnect the debris bag to the vacuum tube.
Do NOT over turn.
If the Velcro
®
Brand fastener strip on top of the debris
bag does not stay secure, rinse well, let it dry and
clean with a stiff brush.
A Helpful Hint: It is easier to empty the debris bag
when it is dry. A second bag may be used while the
full debris bag is drying.
It's best to empty the debris bag when it becomes
half full. The Legend
®
will have better performance
if the bag is not overloaded.
D. Periodic Maintenance
The following parts are wear items that should be
checked, maintained or replaced as needed. Wear
items are considered any working or moving part(s)
being worn due to the use of the cleaner. Wear items
are not covered under warranty.
1. Wall Fitting Screen
Inside the wall fitting is a filter screen that acts as a
secondary filter. This screen is to keep debris that is
passed by the pool filter out of the Legend
®
. Running
the Cleaner without the filter screen can damage the
Legend
®
and will void the warranty.
A continuous plugged or dirty screen is a sign of
problems in your pool filtration system and you need
to contact your local Pool Professional.
To clean the filter screen, pull the screen out from
inside the Wall Fitting and rinse thoroughly and push
back inside the Wall Fitting.
Whenever cleaning, back-washing or repairing the
filter, remove the Wall Fitting and flush out the
dedicated line before using the Legend
®
.
9
To Next Page
Loading...
