LEGEND® INSTALLATION MANUAL
II. Installation Instructions
A. Legend
®
Components
The Legend
®
Box Contains:
1. Cleaner Head
2. Sand & Silt Bag
3. Sweep Hose
4. Complete Feed Hose
a. 1 - 8½” hose
b. 2 - 10’ white (hard) hoses
c. 1 - 30” clear (soft) hose / 1 - 7.5’ clear (soft) hose
d. 10 - Floats
e. 3 - Swivels
f. 1 - Back-up Valve
g. 10 - Mender Nuts
h. 1 - Wall Fitting Complete
B. Pool Connections
The Legend
®
comes equipped to connect to a female
threaded 1-1/2" line, dedicated to our Universal
Booster Pump.
Also, if the pool doesn't have a dedicated cleaner
line, please contact our Technical Support
Department at 1-800-831-7133.
C. Booster Pump Installation
If you already have a 3/4 horsepower booster pump
installed at your equipment pad and it is operational,
skip this section and proceed to Installing the Twist
Lock Pressure Relief Valve (Wall Fitting).
Detailed booster pump installation instructions are
packaged separately in our booster pump box.
Please follow these instructions carefully.
The booster pump is not self-priming and needs to
be fed with water taken from the pool filter before
any type of in-line chlorinator. See figure below.
2
To Next Page
Loading...
