EasyManua.ls Logo

Pentair MASTERTEMP MT200HD - Safety, Warnings & Regulations; Code Requirements; References

Pentair MASTERTEMP MT200HD
160 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
P/N 475106 Rev. D 1/2016 MASTERTEMP
Pool and Spa Heater Installation and User’s Guide
CODE REQUIREMENTS / REFERENCES
Installation must be in accordance with the code requirements:
Manufacturers Installation Instructions
Local Gas Fitting Regulations
Municipal Building Codes
EN 437: 2003 + A1 (2009) Test Gases - Test
pressures appliances categorizes.
EN 60335-2-102/A1 - Household and similar
electric appliances - Safety - 2- 2012
BS 6891 Specification for installation of
low pressure gas pipe work.
BS5482:1 Code of practice for domestic
butane and propane gas burning
installations. Building Regulations|
Part L1.
Local Electrical Regulations
Any other statutory regulations
•E
N 15502-1 : 2012 Gas fired heating
boilers general requirements test.
BS 6644 : 2011 Specifications for
the installation and maintenance of
gas fired hot water boilers between
70Kw - 1.8 mW, (2nd. and 3rd. gas
family).
Code Requirements / References |
iV
IMPORTANT NOTICE:
DO NOT directly connect any external control device to this appliance, unless noted in this Installation and User’s Guide
or recommended by the manufacturer. Any installed control device not recommended by the manufacturer could violate
the Gas Safety Regulations (the installation and use), the above described regulations and the appliance warranty.
The manufacturer’s notices DO NOT supersede any legal requirements.
Gas Safety (Installation and Use) Regulations, (as amended).
It is the law that all gas appliances are installed by a competent person (e.g. a CORGI registered operative) in accordance with Regulations.
Failure to install appliances correctly could lead to prosecution. The installation of the Heater MUST also be in accordance with the
current I.E.E.. Wiring Regulations, the European Building Standards, the Bye Laws of the Local Water Undertaking, any relevant
requirements of the Local Authority, and Health and Safety document No 635, “Electricity at Work Regulations”.
Detailed recommendations are contained in the following European Standard Codes of Practice.
0087
1312

Table of Contents

Related product manuals