5
REBEL™ Suction Side Pool Cleaner Installation and User’s Guide
CLEANER ADJUSTMENTS AND OPERATION
After installation, turn the pool pump on. The Rebel™ Suction Side Pool Cleaner should be moving about the pool
at a rate of 2.5-3.5 metres per minute. Be sure to check each of the following initial adjustments.
Hose Length
Note: The pump must be on when you check the
hose length. The hose contracts when the pump is
operating and will be longer when the pump is off.
While the cleaner is operating:
1. Position cleaner at the furthest point of the
pool from where it’s attached. Use a pool
pole and brush to easily position the cleaner
in the pool.
2. The hose should be long enough to reach the
end of the pool, plus one hose section and
the leader hose. See Figure 12 .
3. Remove any excess hose lengths from the
middle of the hose assembly. This will ensure
you do not alter the position of the hose float.
4. Save extra hose sections for use as needed
for replacement.
Note: Turn pool pump off when adding or
removing hose sections.
Figure 12
Hose must reach furthest point in pool
— —
plus one length
plus
leader
hose
Eyeball Diverter Positions
Position the diverter opening to redirect the return line
water flow so it does not interfere with the cleaner’s
movement. Try different positions to see which works
best in your pool:
• flow directed along the side of pool (the tile line).
• flow directed downward.
• flow directed against the hose will help steer the
cleaner away from obstructions such as stairs and
ladders.
After installing the eyeball diverter, turn the pool pump
on. The cleaner should begin moving across the pool
floor vacuuming up debris in its path.
BEFORE ADJUSTMENT
AFTER ADJUSTMENT
TOP VIEW SIDE VIEW
TOP VIEW SIDE VIEW
Figure 13
To Next Page
Loading...
