PUMP RE-ASSEMBLY (Continued)
11. Install the Filter Screen (M) (Fig. 16)
11.1 Slide the Filter Screen (M) onto the Upper Housing (N).
11.2 Align the slots in the Filter Screen (M) with the screws (V) in the Upper
Housing (N) and slide the Filter Screen (M) over the screws (V).
12. Install the Outlet Fitting (G) (Fig. 16)
12.1 Lubricate the O-Ring (H) and slide it into the O-Ring groove on the Outlet
Fitting (G).
12.2 Push the Outlet Fitting (G) into the hole in the Upper Housing (N).
13. Install the Lift Plate (F) with three the O-Rings (I) on the posts (Fig. 16)
13.1 Lubricate 3 O-Rings (I) and slide them on the Lift Plate (F) posts located on the
bottom side of the Lift Plate (F).
13.2 Align the three posts with the Upper Housing (N) screw holes and press on the
Lift Plate (F) until it is flush against the Upper Housing (N).
Note: DO NOT USE MORE THAN 20 ( 5) in-lb [2.25 Nm ( .5)] TORQUE
TO PREVENT STRIPPING .
13.3 Using a #2 Phillips Screwdriver install the screws (E) 6 places into the
Lift Plate (F).
14. Install the Plug (Cable Adapter) Assembly
Note: The orientation of the Plug (Cable Adapter J) will not affect
performance.
Note: IF IT BECOMES NECESSARY TO REASSEMBLE THE PLUG ASSEMBLY,
REFER TO PUMP CONNECTIONS & INSTALLATION INSTRUCTIONS.
14.1 Align the Plug connector holes with the electrical prongs in the Receptacle (J).
14.2 Push the Plug into the Receptacle (J) until the collar is seated flush.
14.3 Push the Nut (Part D) over the Plug (Cable Adapter) and finger tighten the nut.
Note: Before placing the pump back into the well, operate the pump to
check all electrical connections using the correct power supply.
Refer to Technical Specifications (Pg. 14).
FIGURE 15
I
E
F
G
H
UPPER HOUSING
M
V
To Next Page
Loading...
