Pentax 67 - Unloading Exposed Film

UNLOADING FILM
After you have exposed the proper number of
frames of the type of film you are using, the
shutter will be disengaged to allow turning of
the wind lever continuously. Keep turning the
lever until there is little resistance, and open
the camera back. After pulling out the film re¬
tainer knob, press down on the rim at the top
of the spool. Take out the film and seal the roll.
• Handle the exposed film carefully.
Should the roll of film loosen, accidental
exposure to light may happen damaging
your photographs. Also, do not tighten
the roll too much as this may cause a
damage to the film.
• Do not force the wind lever when it
becomes taut. It may damage the shutter
and/or wind mechanism.
20