43
Place the other AF360FGZ flash unit(s) at the
desired location(s).
q Set the flash unit's power switch to
WIRELESS.
w Set the wireless mode switch to [S].
e Slide down the setting switch to [yellow dot].
Next, press the channel button [CH] and set
the same channel as the AF360FGZ being
attached then slide the setting switch back
up.
r Press the flash mode button and set the
flash mode to P-TTL mode.
t Set the zoom position to Manual [M. Zoom]
y Check that the flash unit on the camera and
the slave flash unit(s) are ready, then take
the picture.
• The two flash units must be set to the same
channel otherwise the flash unit separated
from the camera will not fire.
42
Using two AF360FGZ flash units with one
attached to the camera.
Attach the AF360FGZ flash unit to the camera.
q Set the flash unit's power switch to
WIRELESS.
w Set the wireless mode switch to [M].
e Set the flash zoom position to match the lens
focal length. This will be automatically set
when using auto focus lenses with [A.
Zoom]. Set with the flash zoom button for
other lenses.
To Next Page
