Pentax K-r - Page 57

77420 - 56/107 -
2. [Adjustment] Initialization when replace T100
[Caution] When replacing T100, you must execute this initialization.
[Caution] Use AC adaptor or fully charged battery for adjustment.
[Required equipment]
AC adaptor kit
2 SD cards for K-r adjustment (Product FW, Initialization)
2-1. Writing FW
[Caution] All settings are initialized.
[Caution] Use AC adaptor or Power supply.
①Turn OFF the power.
②Insert SD card for Product FW to the camera then leave
the SD card covers open and keep this condition.
③ Camera read SD card automatically and right screen will display.
*If you cancel the writing, disconnect power first then remove SD card.
④ Remove the SD card when the message [>>> EJECT SD CARD <<<]
is appeared then starting updating.
(It takes approx 90sec for loading firmware)
[Caution] Do not turn OFF the power.
⑤ Display and main power will turn off automatically
when FW installation is finished.
Confirm that the FW is installed. (finish)
2-2. Data initialization
[Caution] All EEPROM data will be initialized. Execute only replacing T100.
① Turn OFF the power
② Insert SD card for initialization to the camera.
③ Turn ON the power while opening SD card cover.
(Initialization will be started. It takes few sec.)
[Caution] Do not turn OFF the power.
④ When display is changed to “COMPLETE…”, it is completed.
Turn OFF the power.

COMPLETE…

VERIFY:****
PENTAXK‑r
UPDATINGDSPFIRMWARE 
SECTOR**>>PROGRAM

NEVERPOWEROFF
PENTAXK‑ｒ
UPDATINGDSPFIRMWARE

****COMPLETE****
VERSION1.00.00.01

POWEROFF 
DETECTEDBOTHF/WFILE
NOWLOADING
DETECTEDFIRMWAREFILE
COMPLETELOADING
‑‑‑‑‑‑‑CPU‑‑‑‑‑‑‑‑
CURRENTVER.1.00.00.00
UPDATEVER.1.00.00.10
=======DSP========
CURRENTVER.1.00.00.00
UPDATEVER.1.00.00.10
>>>EJECTSDCARD<<<