77420 - 83/107 -
④Release by remote control.
⑤[Confirm]Enlarge the image by electric dial on Instant Review.
Confirm at center and four corner of image. The image should be evenly
for right, left, top and bottom and there is no tilting at center of image.
[Tolerance] Pal lax: top and bottom / right and left --- 0.1mm or less (on image screen)
Tilt: Within ±30′(minutes)
When adjusting image shift, adjust as close as zero.
⑥If it is not within tolerance, calculate shift amount (Ratio) and tilted amount then execute following
adjustment.
To Next Page
Loading...
