6/9 27550
aa
0-A373
5-c. [Adjustment & Confirmation] Installing position of Pop-up magnet (G119)
1)
At the flash pop-up condition, the armature of G119 should be
positioned as shown in figure right.
2) Loosen Q3 installing screw and tight again. (Refer to figure in front page)
3) At the flash retracted position, when the armature lever (0-A373) is
pushed toward the back and released, the flash should be pop-up.
4)
After adjustment and confirmation above, apply screw lock to G119, retainer screw and
2 portion of positioning studs.
5-d. [Confirmation] Retraction of the Flash
Confirm after installing the Flash cover (Q1).
1)
At the retracted position, there should be approx. 0.1mm play when Q1 is pushed down
toward as the arrow mark.
2) The flash should not pop-up when the side of Q1 is pushed gently.
[Adjustment]
The choice of thickness or using quantity of Q3
Q3-00A (t=0.2), -00B(t=0.1), -00C(t=0.15)
6. Adjustment and confirmation
The adjustment and confirmation as follow are same as MZ-5.
* Exposure and DX code
* AF check (Except Power zoom function)
* Mechanical back (Standard : 45.46 mm
±
0.02)
* Mirror function
* Position of 1
st
and 2
nd
mirror
6-1. Function check
The exclusive function for MZ-7.
1) Set the mode dial at AUTO PICT
and FA(F) lens at “A” position.
When the main switch is turned on, the LED of the mode dial should light up in order as
follow.
→ → → → → → →
AUTO PICT
2) The LED of the mode dial should correspond as accordingly to the position of the mode dial.
(Continue to next page)
To Next Page
Loading...
