Pentax Optio 430 - Viewing Images on a Macintosh

69
Playback/Erasing
68
Playback/Erasing
Viewing Images with Macintosh
Images recorded with the camera can be edited/printed using a Macintosh
with an USB cable and the included software (S-SW2).
About the included software
The included CD-ROM contains the following software:
- USB driver
- Image viewing software (ACDSee
TM
)
System environment
OS: Mac OS 8.6 or later (QuickTime 4.0 or later required)
CPU: PowerMac 266MHz or higher
Memory: 8MB or more
Hard disk space: 6MB or more
Standard equipped USB port
To view movie pictures on your Macintosh, QuickTime 4.0 or later
pre-installed on system is required.
Installing the software
The procedures for installing the necessary software are
explained.
Installing the USB driver
z Turn on your Macintosh.
x Set the included CD-ROM in the CD-ROM drive of your
Macintosh.
c Copy the following 2 files to the [Extensions] folder
within the System folder.
PENTAX-USB Storage Driver
PENTAX-USB Storage Shim (E)
v Restart your Macintosh.
Optio 430 is usable to USB mass storage class. For MacOS X and
MacOS 9.x, there is no need to install the USB driver.
Installing ACDSee
TM
When installing ACDSee
TM
, recorded images can be viewed on
your Macintosh.
z Turn on your Macintosh.
x Set the included CD-ROM in the CD-ROM drive of your
Macintosh.
c Double click [English] on the CD-ROM (S-SW2).
v Follow the on-screen guidance and enter the registration
information and proceed with the installation.
memo
KB320(53-71)E.QE33 9/12/01 4:19 PM Page 68