Pentax Optio S50 - Using the Self-Timer

52
Taking Pictures
4
- d R + C . H =
1 Press the four-way controller (2) in Capture mode to
display g or r on the LCD monitor.
2 Press the shutter release button halfway.
The focus frame turns green if the subject is in focus.
3 Press the shutter release button
fully.
g The self-timer is engaged and the self-
timer lamp lights for about seven
seconds. The picture is taken
approximately three seconds after the
self-timer lamp starts to blink.
r The self-timer is engaged and the picture is taken approximately
two seconds after the self-timer lamp starts to blink.
Using the Self-Timer
Focusing position may shift if you move the camera while the self-timer
lamp is blinking.
• The second count appears if you turn the LCD monitor on.
• To cancel the self-timer, press any button, such as the MENU button,
while the second count is displayed.
Taking Pictures of Yourself
1p.43
Troubleshooting: “Subject is not in focus”
1p.129
2
1
44
10:25
1 0 : 2 5
10:25
04/25/2004
0 4 / 2 5 / 2 0 0 4
04/25/2004
e_kb376.book Page 52 Tuesday, August 10, 2004 1:46 PM