J
jandersonAug 5, 2025
What to do if the radio remote LED’s, voltage indicator, and green button are not working on my Pentruder Saw?
- JJames KerrAug 5, 2025
If the radio remote LED’s, voltage indicator, and green button are not working on your Pentpak Saw, try these steps: Ensure the Pentpak is connected to the mains supply. Connect the remote to the Pentpak, making sure the stop circuit is activated by pressing the green button and following the startup sequence. If connected via radio, reposition the RRC to ensure it's in range. If using a cable, disconnect and reconnect the CE-RRC cable. Also, verify that the remote is paired to the Pentpak. If the issue persists, it may be due to a faulty remote control board or an RRC battery charging error, and you should contact your Pentruder authorized service workshop.

