Pentruder RS2 - When cutting is finished; Storage of the machine

Operator’s manual Pentruder RS2 wall saw and Pentpak 3 HFi power pack – Original instructions Page 33
Feed and power regulation, PWR – Feed and power regulation knob
17. Set the PWR knob in the chosen setting.
As long as the blade is spinning in the air, the PWR knob is used only to control speed on the track. From the
moment the blade touches the concrete, and a pre-set amperage draw is exceeded, the PWR knob changes
its function and is used to control the power (ampere) used to drive the blade. (D5)
Note!
• The PWR-knob can usually be set at 100% during cutting.
• To be able to run on a smaller fuse (e.g., 16 A), the PWR knob can be lowered to
a setting where the fuse will not cut out. Look at the display and turn the PWR
knob to a preferred setting.
Plunge and travel (Joystick)
18. Move the Joystick up or down to rotate the radial saw arm. (D5)
19. Move the joystick left or right to move the saw head along the track. (D5)
20. The saw arm will always stop when it is “straight up” to facilitate mounting. Just flick again with the joystick
to continue the movement on the saw arm.
Note!
A pre-cut not deeper than approximately 5 cm / 2 inches is always recommended
to avoid that the saw blade cuts un-straight.
When cutting is finished
Stop the blade
To stop the blade, push the switch for the main motor (MS) upwards once.
Switch for water
Move the switch forward to start and stop the water flow through the machine. The water flow will be switched on
automatically when the blade is started. The water will be left running when the blade motor is stopped, and the
water must be switched off by pushing the WS Water ON/OFF switch once again.
!
Important!
• To protect the motors from overheating, they will be switched off automatically
if the temperature becomes too high. The coolant water should then be left
running through the power pack and machine to avoid terminal overheating.
Storage of the machine
• Disconnect the cables from the power pack before transporting the machine.
• The saw blade and blade guard should be taken off the saw head before transport.
• Make sure no unauthorized persons can get access to the machine when in transport and storage.
• If there is a risk of freezing, the machine must be drained from water. Pay extra attention to the power pack.
See 3.7.2 Cooling Water.
• Store the machine in a dry place, preferably above freezing temperature.
• Follow the saw blade manufacturer’s instructions for handling and storage of the saw blade.
• See also 3.2 Transport,
!
Important!
• Do NOT leave the power pack outside in the rain. The unit is sealed but not
watertight over time. To prevent possible damage to electronic components
we recommend that it is kept dry to prevent excessive condensation forming.