This setting specifies the transmit rate to be used for sending multicast
network traffic. The selected Protocol and Channel Bonding settings will
affect the rate options and values available here.
To allow the Pepwave router to listen to internet group management protocol
(IGMP) network traffic, select this option.
Layer 2 refers to the second layer in the ISO Open System Interconnect
model.
When this option is enabled, clients on the same VLAN, SSID, or subnet are
isolated to that VLAN, SSID, or subnet, which can enhance security. Traffic
is passed to the upper communication layer(s). By default, the setting is
disabled.
Maximum Number of
Clients
A
Indicate the maximum number of clients that should be able to connect to
each frequency.
To reduce 2.4 GHz band overcrowding, AP with band steering steers clients
capable of 5 GHz operation to 5 GHz frequency.
Choose between:
Force - Clients capable of 5 GHz operation are only offered with 5 GHz
frequency.
Prefer - Clients capable of 5 GHz operation are encouraged to associate
with 5 GHz frequency. If the clients insist to attempt on 2.4 GHz frequency,
2.4 GHz frequency will be offered.
Disable - Default
A
- Advanced feature. Click the button on the top right-hand corner to activate.
This setting configures the wireless authentication and encryption methods.
Available options :
● Open (No Encryption)
● Enhanced Open (OWE)
● WPA3 -Personal (AES:CCMP)
● WPA3 -Enterprise (AES:CCMP)
● WPA2/WPA3 -Personal (AES:CCMP)
● WPA2 -Personal (AES:CCMP)
● WPA2 – Enterprise
● WPA/WPA2 - Personal (TKIP/AES: CCMP)
To Next Page
Loading...
Need help?
General
