Scenario 1: SIM Injector in LAN of Cellular Router
Setup topology
This is the most basic scenario in which the SIM Injector is connected directly to the cellular
router’s LAN port via an ethernet cable. This allows for the cellular router to be positioned for the
best possible signal. Meanwhile, the SIM cards can be conveniently located in other locations
such as the office, passenger area, or the bridge of a ship. The SIM Injector allows for easily
swapping SIM cards without needing to access a cellular router.
IMPORTANT: Cellular WAN will not fallback to the local SIM if it is configured to use the SIM
Injector.
Configuring the SIM Injector
1. Connect the SIM Injector to the LAN port of the cellular router.
2. Insert SIM cards into the SIM Injector. The SIM cards will be automatically detected.
IMPORTANT: SIM cards inserted into SIM Injector must not have a PIN code.
Note 1: The SIM Injector gets its IP address via DHCP and doesn't have a static IP address. To
find it’s address, please check the DHCP lease on the cellular router.
To Next Page
Loading...
Need help?
General
