peplink Surf - 4.8 Restore to Factory Defaults

PePLink Surf User’s Manual v2.6
Copyright © 1999-2006 PePLink Ltd. All Rights Reserved Page 20 of 30
4.8 Restore to Factory Defaults
To restore the PePLink Surf to factory defaults, there are two methods.
If you are able to access the web admin interface, go to the “CPE Setup”
page, and click the “Restore and Reboot” button.
Otherwise, you can also power up the unit and wait for about 1 min. Then
press the Reset button at the rear side of the unit using a pin and then hold
it for 5 secs. The unit will restore the settings to factory defaults and
reboot.