PMI360DV-F130-IU2E2-V15
Output function in normal operation
2015-06
19
Voltage output:
After the measurement range is exceeded, the analog output value retains the last displayed
value until the position of the actuator falls within the analog measurement range again
(depending on the rotation direction, i.e. 0 V or 10 V).
When the position falls within the programmed measurement range again, the output value is
updated according to the position of the actuator and adopts the programmed function.
Function when actuator is lost
If the actuator leaves the detection range of the angular positioning system (e.g. actuator is
removed), the function of the output depends on whether the analog output assumes the
function of a voltage or a current output.
Current output:
The output current retains the last valid value for 0.5 seconds. The output current then switches
to a value of 3.6 mA in order to signal a fault. This current value is output until the actuator falls
within the detection range of the angular positioning system again and the output value is
updated.
Voltage output:
The output voltage retains the last valid value. This value is output until the actuator falls within
the detection range of the angular positioning system again and the output value is updated.
To Next Page
Loading...