PePWave Surf/Mesh Connector/CarFi Series User Manual
Roaming Settings (applicable to CarFi Series): To configure and enable roaming among
APs with the same SSID and authentication method.
Signal Level Threshold: If the signal level of connected AP falls below the specified value,
the unit will attempt to roam to another AP with a better signal level.
IP Settings: The IP address can be obtained automatically or configured manually. If you
choose to manually configure the IP address for your unit, enter the fields “IP Address”,
“Subnet Mask”, “Default Gateway”, “Preferred DNS Server” and “Alternate DNS Server”.
MTU Size: You may also set the MTU Size to increase the data packet size your unit can
handle at one time.
AP Settings (applicable to Surf AP Indoor/Outdoor and CarFi Series): The AP
Settings will be covered in detail in the subsequent section Integrated Wi-Fi Access Point
Configuration.
WAI redirection: If the device is not connected to an access point, and the user is
accessing an Internet web site, the settings control whether to redirect the web access to
the web admin interface page or not. If this is disabled and the device is not connected, the
browser will show a web access error message. The user can still access the web admin
interface by accessing to the device’s LAN IP address. By default, the LAN IP address is set
as http://192.168.20.1 .
Web Password Protection: Sets the password to protect the web user interface.
Restore default settings: To restore the device to default settings. When this option is
clicked, default settings will be restored and the unit will be restarted.
Reboot: To restart the device.
To Next Page
Loading...
Need help?
General
