Pepwave Surf Series User Manual

PePWave Surf/Mesh Connector/CarFi Series User Manual
Page
4
3 Product Description
It associates to a service provider and authenticates using 802.1x (if needed) on start up.
Upon successful association and authentication, it will acquire an IP address from the
service provider using DHCP. A DHCP server is built-in on its LAN port. Network Address
Translation is performed for all outbound connections. Thus it supports multiple terminals
to access the Internet simultaneously.
3.1 Features
— 10/100 Ethernet interface with auto-crossover detection
— Reset button for restoring settings to factory defaults
— Signal strength LED for showing the current signal strength (Applicable to PePWave
Surf indoor and DX series)
— WPA/WPA2-Personal and WPA/WPA2-Enterprise support
— Network Address Translation (NAT) routing
— Built-in DHCP server
— Inbound port range forwarding
— Integrated Wi-Fi Access Point (Applicable to Surf AP indoor/outdoor and CarFi series)
Surf 200, AP 200, AP 400
Surf
AP 200
-
X
/400
-
X,
MC 200-X, 400-X
Surf
400
-
DX
MC 200, 400
CarFi 200, 400

Pepwave Surf Series Specifications

General

Brand	Pepwave
Model	Surf Series
Category	Wireless Access Point
Language	English