Pepwave Surf Series - Surf Indoor Series Hardware Setup; Surf;Mesh Connector Outdoor Series Setup; Mesh Connector Indoor;CarFi Series Hardware Setup

PePWave Surf/Mesh Connector/CarFi Series User Manual
Page
5
3.2 Hardware Setup
3.2.1 Surf Indoor Series
1. Attach the provided antenna to the left most antenna connector
2. Connect the LAN port to the computer’s Ethernet port with an Ethernet cable.
3. Connect the end of the included power adapter to the power socket (labeled “DC 5V”)
on PePWave Surf.
4. Power on the power adaptor.
3.2.2 Surf / Mesh Connector Outdoor Series
Please follow the installation guide to set up the PePWave AP 200/400-X, Surf 400-DX, MC
200-X / 400-X devices.
3.2.3 Mesh Connector Indoor / CarFi Series
1. Attach the antenna provided to the left most antenna connector
2. Connect the LAN port to the computer Ethernet port with an Ethernet cable.
3. Connect the end of the included power adapter to the power socket on the PePWave
Mesh Connector Indoor or CarFi device.
4. Power on the power adaptor.