PePWave Surf/Mesh Connector/CarFi Series User Manual
4.9 Restore to Default Settings
4.9.1 Surf Indoor Series
There are two ways to restore the PePWave Surf Indoor unit to default settings.
If you are able to access the web admin interface, go to the “CPE Setup” page, and click the
Restore and Reboot button.
Otherwise, you can also power up the unit and wait for about 1 min. Then press the Reset
Button at the rear side of the unit using a pin and then hold it for 5 seconds. The unit will
restore the settings to factory default and reboot.
4.9.2 Surf DX Series
There are two ways to restore the PePWave Surf DX to default settings.
If you are able to access the web admin interface, go to the “CPE Setup” page, and click the
Restore and Reboot button.
Otherwise, you can also power up the Surf DX unit and wait for about 1 min. Then push the
Reset Button at the panel side of the unit and then hold it for 5 seconds. The unit will
restore the settings to factory default and reboot.
4.9.3 Surf AP Outdoor / Mesh Connector Outdoor Series
There are two ways to restore the PePWave Surf AP outdoor/ Mesh Connector outdoor
device to default settings.
If you are able to access the web admin interface, go to the “CPE Setup” page, and click the
Restore and Reboot button.
To Next Page
Loading...
