Pepwave Surf Series User Manual

PePWave Surf/Mesh Connector/CarFi Series User Manual
Page
25
Otherwise, you need to open the cover of the outdoor device and also power up the device
and wait for about 1 min. Then push the Reset Button (see the illustration blow) and then
hold it for 5 seconds. The device will restore the settings to factory default and reboot.
4.9.4 Mesh Connector Indoor / CarFi Series
There are two ways to restore the PePWave Mesh Connector Indoor or CarFi unit to default
settings.
If you are able to access the web admin interface, go to the “CPE Setup” page, and click the
Restore and Reboot button.
Otherwise, you can also power up the unit and wait for about 1 min. Then push the Reset
Button at the rear side of the unit using a pin and then hold it for 5 seconds. The unit will
restore the settings to factory default and reboot.

Pepwave Surf Series Specifications

General

Brand	Pepwave
Model	Surf Series
Category	Wireless Access Point
Language	English