SLG2008A
Owner’s Manual
15
4.
Ignite only the burners
you
wish to use, using the same method for each:
Push desired burner valve knob and rotate slowly about 1/4 counterclockwise until a click is heard. The burner should
light. If the burner does not light, return the valve knob to the “OFF” position immediately. Wait five minutes for the gas
to clear and repeat the procedure. After burner is lit, repeat the procedure with any other burner desired.
5. Adjust valve knob(s) to desired cooking temperature.
Using the Lighting Stick to Light the
Main Burners
1.
Light a match by inserting it into the end of a lighting stick.
2.
Once lit, place the flame through
the hole on grill body to reach the
burner ports.
(See diagram to right.)
3.
Press the valve knob and rotate it counterclockwise to the ‘’HIGH’’ position. The
burner should light immediately.
If more than
one burner is desired, repeat the
same procedure for
the adjacent burner and continue in sequence until all
desired burners are lit
.
4.
Adjust burners to the desired cooking temperature.
Precautions
1.
After lighting, observe the
burner flame.
Make sure all burner ports are lit.
2.
If the burner flame goes out during operation, immediately turn
the gas “OFF”.
Open
lid to let the gas clear for at least
5 minutes before re-lighting.
3.
Before
cooking on the grill for the first time, operate the
grill for approximately 15
minutes
with the lid closed and the gas
turned on “HIGH”.
This
will
“heat clean” the internal parts and dissipate odor from the manufacturing process and painted
finish.
4.
Clean the grill after each use. DO NOT
use
abrasive or flammable cleaners. This may damage parts of the grill and cause a
fire.
Side Burner
1. Open lid
while lighting the burner. Lid must remain open
while burner is lit.
2. Valve
must be in the “OFF” position.
3. Open cylinder valve.
4
.
Push side burner knob fully and rotate it slowly about 1/4 turn counterclockwise, and then press the igniter promptly. The
burner should light. If the burner does not light, turn the knob to the “OFF” position immediately. Wait five minutes for the gas
to clear and repeat the procedure.
5. Adjust valve knob to the desired cooking temperature
Using the Lighting Stick to Light the
Side
Burner
1. Open lid
while lighting the burner. Lid must remain open
while burner is lit
2. Remove the lighting stick then insert a match into
the end of lighting
stick. Light the match.
3. Once lit, place the flame to reach the
burner ports.
4. Press the control knob and rotate it counterclockwise to the ‘’HIGH’’
position. The burner should light immediately.
5.
Adjust burner to the desired cooking temperature.
Observe flame
height
when lit:
Flame
should
be a blue/yellow
color between 1 to 2 inches
high.
2 in.
1 in.
0 in.
To Next Page
Loading...
