EasyManua.ls Logo

Perfect Flame 61701 - Rotisserie and Maintenance; Rotisserie Operation and Safety

Perfect Flame 61701
24 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SLG2008A
Owner’s Manual
17
8. Wait for at least 5 minutes.
9. Re-connect the regulator to the LP tank.
10. Slowly turn the LP tank valve ¼ turn at a time and have the valve all the way open.
11. With the lid open: For grill with ignition button: turn on only ONE front burner control knob to the HIGH position. Ignite the
grill by pushing the ignition button. For grill with an automatic ignition: Push down the control knob you want to light, turn
counterclockwise until you hear the ignition click.
12. After the first front burner is lit, turn on the other control knob(s) to the HIGH position. **If you have more than two burners,
turn them on only ONE AT A TIME.
13. When all front burners are lit, close the grill lid.
14. Wait for 10-15 minutes; the temperature should reach 400 – 450°F
WARNING: The cylinder valve always has to be above the horizontal position, for the cylinder to have vapor withdrawl
only.
Rotisserie Operating Instruction
IMPORTANT: YOUR GRILL MAY BE EQUIPPED WITH ROTISSERIE BURNERS. THE INSTRUCTIONS BELOW
INCLUDE OPERATION FOR GRILLS EQUIPPED WITH A ROTISSERIE BURNER AND
INSTRUCTIONS FOR GRILLS NOT EQUIPPED WITH ROTISSERIE BURNERS. BE SURE TO
FOLLOW THE INSTRUCTIONS APPROPRIATE FOR YOUR GRILL.
IMPORTANT SAFETY INSTRUCTIONS
CAUTION - TO PROTECT AGAINST SHOCK HAZARD.
CONNECT ONLY TO A PROPERLY GROUNDED OUTLET.
Please read the following safety precautions before using the rotisserie motor.
1. Read all instructions before assembly, installation and use.
2. Do not touch hot surface with bare hands.
3. To protect against electrical shock do not immerse cord, plug, or motor in water or other liquid.
4. Close supervision is necessary when any appliance is used by or near children.
5. Unplug from outlet when not in use and before cleaning. Allow to cool before putting on or taking off parts. Do not clean this
product with a water spray or the like.
6. Do not operate any appliance with a damaged cord or plug or after the appliance has been damaged in any manner.
7. The use of other accessory attachments is not recommended by the appliance manufacturer as it may cause injuries.
8. Do not let the electric cord touch hot surfaces or hang over the edge of a table or counter.
9. Do not place on or near a hot gas or electrical burner, or in a heated oven.
10. Caution must be used when assembling the pointed end of a spit rod and the meat forks as the ends are sharp.
11. Always attach plug to appliance first, then plug cord into the wall outlet. If the plug does not fit in the outlet, contact a
qualified electrician. DO NOT attempt to modify the plug or override this safety feature.
12. Do not use this appliance other than for the intended use.
CORRECT
WRONGWRONGWRONG

Related product manuals