4
INFRARED SEARING SIDE BURNER
Inspect the gas supply hose prior to turning on the gas. If there is evidence of cuts, wear or
abrasion, it must be replaced prior to use. Do not use the side burner if gas odor is present.
Keep a spray bottle of soapy water near the grill and check the gas connections before each
use.
ROTISSERIE DRIVE MOTOR
To ensure continued protection against electric shock:
Connect to properly grounded outlets only.
Keep extension cord connections dry and off the ground.
Do not expose to rain.
Do not use indoors.
CAUTION
1. The grill head is heavy and will require two or more people to lift and position onto grill cart.
2. Before cleaning, make sure the gas supply and control knobs are in the “OFF” position and the burners
have cooled.
3. When using a match to light the grill make sure to use the attached lighting rod.
4. When using the rotisserie burner, remove the warming rack. High heat from the rotisserie burner may
cause the warming rack to bend.
5. Do not alter the grill in any manner.
6. Clean and inspect hoses before each use. If there is evidence of abrasion, wear, cuts or leaks, the hose
must be replaced prior to operation. The replacement hose should be in accordance with the
manufacturer’s specifications.
BEFORE LIGHTING
Inspect the gas supply hoses prior to turning on the gas. If there is evidence of cuts, wear, or abrasion, it
must be replaced prior to use.
Use the pressure regulator and hose assembly supplied with the grill. Never substitute regulators for those
supplied with the grill. Contact customer service for proper replacement parts.
Leak test the piping and regulator connections with a 1 part soap and 1 part water solution before operating
the grill (See “Leak Testing” instructions on page 14).
Do not turn “ON” the gas supply at the Natural gas shut off valve unless the Quick-Connect gas hose is
properly connected to the side burner gas pipe system and all burner valves are in the “OFF” position.
WARNING
Do not try lighting this appliance without first reading the “LIGHTING INSTRUCTIONS” section
of this manual.
To Next Page
Loading...
