1/01 E Service Instructions 9
Clamping
System
Fig. 7
7
1
4
6
5
8
3
9
2
Fig. 6
Keeping specified gap s, it is im-
portant to bring the clamping pres-
sure as close as possible to the
cutting line.
Gap s shown in Fig. 6 should be
0.2 + 0.1 mm.
Clamp 1 can be readjusted with
respect to cutting line 2 as fol-
lows:
In addition to gap s between the
knife back and the clamp edge,
the play of the clamp in its
guideways is decisive to obtain a
high-quality and high-accuracy
cut.
Gap Between the
Knife Back and the
Clamp Edge
Machine Size 76 (Fig. 7)
• Slacken screws 3 to release
clamp guideway 4 at the clamp
left and right rear sides.
• Adjust required gap s by means
of shims 5 to be inserted between
clamp 1 and clamp guideway 4.
Inserting shims reduces the gap
by the shim thickness, while re-
moving shims widens the gap.
The shims are 0.05 and 0.2 mm
thick. Refer to the Spare Parts
Catalogue in the Operating In-
structions manual.
• Tighten the clamp guideway
and check the gap across the
entire cutting width with a feeler
gauge.
To Next Page
Loading...