PERFECTPRO DIGITUBE - Aux-In Mode; Manually Setting Clock

1817
AUX-IN MODE
A3.5mmstereoAux-Insocketisprovidedonthesidebehindtherubbercover,forconnectinganexternalaudiodevicesuchasMP3
playerorCDplayer(Auxcablenotincludedwiththisradio).
1. Connect an audio source to the AUX-IN socket.
2. Press the SOURCE button to select AUX input. Display will show “AUX IN”.
3. Play the external player.
4. Adjust the VOLUMEofboththeradioandtheplayerforcomfortablelistening.
5. Afteruse,closetherubbercovertopreventmoistordustfromenteringintothesocketsandradio.
Notes:NeverusetheAux-Insocketinrainyormoistconditionstopreventmoistfromenteringtheradio.Keeptherubbercoverwell
closed under these conditions.
TheAuto-PowermanagementfunctionwillbeactivatedinAUXmode.Ifthereisnosignal*fromtheAux-Insocketforaperiodof
over 15 minutes, the DigiTube radio will automatically switch to standby mode. Pressing the On/Off button will wake up the unit.
* Alsowhentheincomingsignalfromtheexternaldeviceistoolowandcannotbedetectedforaperiodofover15minutesbythe
Auto-Power management, the DigiTube radio will switch to standby mode.
Topreventthisraisetheoutputleveloftheexternaldeviceenoughtobedetected.
MANUALLY SETTING CLOCK
Theclockcanonlybemanuallysetwhentheradioisinstandbymode.Ifnobuttonsarepressedfor5seconds,theradiowillexitthe
clock setup and the setting is cancelled.
1. Press the MENUbuttonforabout3seconds,andthedisplaywillshow“CLOCKSET”.
2. Press the SELECT-INFObutton.Thehourdigitsashonthedisplay.
3. Press the TUNING or buttons to set the hour
4. Press the SELECT-INFObuttontoconrm.Theminutedigitsash.
5. Press the TUNING or buttons to set the minute.
Bluetooth LED
ThemenuoftheradiocanbeconguredtoBluetoothLED.
1. Press the On/Off button to turn on the radio.
2. Press the MENU button, and then press the Tuning
or buttons until the display shows “System”.
3. Press the SELECT-INFO button; then press the Tuning or button until the display shows “Bluetooth LED”.
4. Press the SELECT-INFO button to enter the Bluetooth LED adjustment menu.
5. Press the Tuning
or buttonstoselect“on”(bydefault)inordertokeepBluetoothLEDlightenedwhenconnected;
6. Or Press the Tuning or buttonstoselect“off”toturnoffBluetoothLEDwhenBluetoothconnectionhasbeen
established.
7. Press the SELECT-INFObuttontoconrmyourchoice.TheBluetoothLEDwillbechangeduponthelatestselection.
GB
GB