PERFECTPRO DIGITUBE - Preset Stations

13 14
RDS station service – FM
RDS(RadioDataSystem)isaninformationsystemwhichinaudibledigitalinformationistransmittedinadditiontothenormalFM
radioprogram.WhentheradioisreceivingaRDSstationandthereceptionstrengthissufcient,thestationnamewillappearinthe
display.ItmaytakesometimebeforetheRDSinformationisavailable.
Calling up RDS information
When you are listening to a FM station with RDS system, repeatedly press the SELECT-INFO button to cycle through the
information.Thiswillonlyfunctionifthereceptionlevelissufcientandclear.
a. Stationname(PS) Displaysthenameofstationbeinglistenedto.
b. Radiotext(RT) Displaysthemessageaboutthestationbeinglistenedtoastickertext.
c. Programtype(PTY) Displaysthetypeofstationbeinglistenedto,e.g.Pop,Classic,News,etc.
d. Frequency Displaysthefrequencyofthestationbeinglistenedto.
e. Signal level Displays the signal strength.
f. Time&date Displaysthecurrenttime(24hourclock)anddate.
Scan sensitivity setting – FM
TheradiowillnormallyscanallstationsfromFMbroadcastsincludingtheweakersignals.However,youmaywishtheAuto-scanto
ndonlythosestationswithstrongenoughsignalstogivegoodreception.
1. Press the On/Off button to switch on the radio.
2. Select the FM band by pressing the SOURCE button.
3. Press the MENU button, the display shows “Scan”.
4. Press the SELECT-INFO button .
5. Press the TUNING or buttonstoselect“All”or“Strong”(defaultis“Strong”).The“Strong”stationoptionwillallowthe
radiotondstrongsignalsonlywhenscanning.
6. Press the SELECT-INFObuttontoconrmyoursetting.Thedisplaywillreturntonormalradiodisplay.
PRESET STATIONS
Storing preset stations
Thereare20memorypresetsintheradio,10forDABand10forFM.Presetsarerememberedbytheradiointheeventofapower
failure.
1. Press the On/Off button to switch on the radio.
2. Select the desired waveband by pressing the SOURCE button.
3. Tunetotherequiredstation.
4. Press(for1sec.)theMENU-PRESET button until “Preset” is displayed.
5. Press the TUNING
or buttonstoselectthedesiredpresetnumber(fromP1toP10).
6. Press(for1sec.)theSELECT-INFObuttondisplaywillshow“Saved”toconrm.
7. Repeatsteps3to6fortheremainingpresets.
8. Stationsstoredinthepresetmemoriescanbeover-writtenbyfollowingtheaboveprocedure.
Recalling preset stations
1. Press the On/Off button to switch on the radio.
2. Select the desired waveband by pressing the SOURCE button.
3. Press(for1sec.)theMENU-PRESETbuttonuntil“Preset”isdisplayed.Thedisplaywillshowthestationfrequencyandthe
preset number.
4. Press the TUNING or buttons to select the desired preset station, then press SELECT-INFOtoconrm.
USING BLUETOOTH
Pairing Bluetooth with your mobile phone
1. Press the On/Off button to switch on the radio.
2. Select Bluetooth mode by pressing the SOURCE button.
3. The blue Bluetooth connected LEDonthefrontwillbeblinkingwhentheDigiTube radio is not yet paired with your mobile
phone.
GB
GB