Performance Designs PD Series User Manual

MAN-0012 Rev. I Page | 26
The first 15-20 deployments will cause the Slink to take a more permanent “set”. It is important to ensure
that the tab is located between the risers during this period so as to insure this set occurs with the tab in
the proper position. Once this has occurred, the Slink will have a tendency to remain in this position. If this
procedure is not followed, the tab may rotate out of position. Allowing the tab to remain outside of the
risers during deployment and flight will result in excessive wear of the Slink, potentially leading to
structural
failure.
Note: Should you find that the tab does not remain in place, PD recommends tacking the
tab to ensure it stays
locked between the risers.

Performance Designs PD Series Specifications

General

Brand	Performance Designs
Model	PD Series
Category	Accessories
Language	English