Performance Designs PD Series User Manual

MAN-0012 Rev. I Page | 27
TOGGLE ATTACHMENT: MICROLINE STEERING LINE WITH FACTORY MADE LOOP
If your Performance Designs reserve has factory made loops on the steering lines follow these
instructions:
1. Once the steering line is routed through the guide ring on the riser, continue by
routing the steering line through the grommet on the steering toggle. Always
start routing from the hook and loop fastener side. Figure 1
2. Now slide the loop over the lower end of the steering toggle and pull the steering
line through. Figure 2
3. Finally, the loop should be tight around the toggle and centered on the grommet.
Figure 3
NOTE: Prior to hooking up the
steering toggles, ensure that the
steering line passes through the
grommet on the slider as shown.
THIS STEP MUST BE
FOLLOWED PRIOR TO
ATTACHING THE TOGGLES TO
STEERING LINES,
REGARDLESS OF THE TYPE OF
STEERING LINE BEING USED.

Performance Designs PD Series Specifications

General

Brand	Performance Designs
Model	PD Series
Category	Accessories
Language	English