MAN-0012 Rev. I Page | 34
8) Flake the material between
the A and B lines away from
the line channel in the center
of the pack job. Be sure that all
three T seams to the right of
the center cell are neatly
flaked.
9) Find the four bottom seams
to the right of the center cell
and flake them out toward the
stabilizer. The bottom seams
are where the loaded ribs meet
the bottom skins.
Make sure the right side B lines
are grouped together and
stacked neatly on top of the A
lines.
10)
between the A and B lines.
Repeat steps 8 through 10 to
flake the material between the
B and C lines.
To Next Page
Loading...