2
SPECIFICATIONS
Specifications are subject to change without notice
IMPORTANT SAFETY INFORMATION
WARNING!
READ, UNDERSTAND AND FOLLOW ALL INSTRUCTIONS AND
WARNINGS BEFORE OPERATING THIS TOOL. FAILURE TO DO
SO MAY RESULT IN PERSONAL INJURY AND/OR PROPERTY
DAMAGE AND WILL VOID WARRANTY.
1. Keep work area clean. Cluttered areas invite injuries.
2. Observe work area conditions. Do not use machines or power tools in damp or wet
locations. Don’t expose to rain. Keep work area well lighted. Do not use electrically
powered tools in the presence of ammable gases or liquids. Do not bring combustible
materials near the tools.
3. Keep children away. Children must never be allowed in the work area. Do not let them
handle machines, tools, hoses or extension cords.
4. Store idle equipment. When not in use, tools must be stored in a dry location to inhibit
rust. Always lock up tools and keep out of reach of children and other untrained
persons. Switch o all unused electrical tools when stored. Tools are dangerous in the
hands of untrained users.
5. Always wear approved eye protection when using tools. If raising dust, wear a suitable
mask.
6. Work Safe. When wearing gloves to operate the Air Hammer, make sure that the
gloves do not interfere with operating the Trigger (11). Test your gloves with the Trigger
(11) before attaching the unit to an air source. Keep your nger away from the Trigger
(11) until you are ready to work. Never start the tool unless you have a rm grip with
Bore Size (IN) ................................................................... 3/4
Stroke Length (IN) ............................................................1.7
Air Pressure (PSI) ............................................................... 90
Average Air Consumption (CFM) .......................................4
Free Speed (BPM) .........................................................4,500
Air Inlet (NPT) .............................................................. 1/4 in.
Hose Size (ID) .............................................................. 3/8 in.
Length (IN) .........................................................................5.1
Weight (LBS) ......................................................................2.2
Warning!
Oil tool before each use. 4 to 5 drops of a good grade Air Tool Oil
placed in the air inlet is sufficient. Use proper air pressure and CFM
rating listed for this tool.
To Next Page
Loading...
